Difference between revisions of "Hardware/SATA controller"
< Hardware
Jump to navigation
Jump to search
m (Link to correct version of AHCI spec) |
|||
| Line 66: | Line 66: | ||
== See Also == | == See Also == | ||
| − | [https://www.intel. | + | [https://www.intel.in/content/dam/www/public/us/en/documents/technical-specifications/serial-ata-ahci-spec-rev1_2.pdf AHCI 1.2 spec] |
Revision as of 23:48, 10 December 2019
| SATA controller | |
| Access | |
|---|---|
| Espresso | None |
| Starbuck | Full |
| Registers | |
| Base | 0x0d160000 |
| Length | 0x10000 |
| Access size | 32 bits |
| Byte order | Big Endian |
| IRQs | |
| Espresso | ??? |
| Latte | ??? |
The Wii U has a standard AHCI 1.2 SATA controller onboard. It identifies as having two ports (0 and 1) running at 3Gbps. In retail systems, the disc drive is connected to port 0; while port 1 is disconnected. Unused code in IOS-BSP indicates that port 7 may be present on non-retail units.
In terms of hardware registers; the controller lines up with the specification starting at address 0x0D160400; that is; the first Generic Host Control register (Host Capabilities) resides at 0x0D160400. On a retail console, this register reads out 0x7720FF81.
Registers
- The generic host control registers start at 0x0D160400.
- The port registers start at 0x0D160500.
ATAPI commands
Besides commands defined in the ATAPI specification, the Wii U also seems to have some custom commands.
0xDA - ATAPI_DI_READ_DISC_INFORMATION_CMD
0xE0 - ATAPI_DI_REQUEST_ERROR_ID_CMD
0xED - ATAPI_DI_READ_CBC_CMD
0xF0 - ATAPI_CF_REQUEST_DRIVE_ID_CMD
0xF1 - ATAPI_CF_AUTHENTICATE_CMD
0xF2 - ATAPI_CF_START_STOP_UNIT_CMD
0xF3 - ATAPI_CF_READ_CMD
0xF4 - ATAPI_CF_TEST_UNIT_READY_CMD
0xF5 - ATAPI_CF_INQUIRY_CMD
| Offset | Size | Description |
|---|---|---|
| 0x00 | 0x02 | Unknown |
| 0x02 | 0x01 | Vendor |
| 0x03 | 0x01 | Device |
| 0x04 | 0x1C | Unknown |
| 0x20 | - | End |