Changes

| 0x1F || 0x1F || int set_fault_behavior(int pid, u32 flag) || Enables or disables raising a panic when a system fault occurs in the specified process. This is only usable from the IOS-MCP process. Once finished, this will always set the flag for PID0(IOS-KERNEL) to value 1. This is the same field mentioned [[IOSU|here]] for exception handling. || 0 on success, -1 when curpid is not 1, and -29 when the input pid is >13.

| 0x1F || 0x1F || int set_fault_behavior(int pid, u32 flag) || Enables or disables raising a panic when a system fault occurs in the specified process. This is only usable from the IOS-MCP process. Once finished, this will always set the flag for PID0(IOS-KERNEL) to value 1. This is the same field mentioned [[IOSU|here]] for exception handling. || 0 on success, -1 when curpid is not 1, and -29 when the input pid is >13.

|-

|-

| 0x20 || 0x20 || int get_key_type() || Gets the key type from the OTP (only 0 is valid) || 0 on success

| 0x20 || 0x20 || int check_debug_mode() || Checks if we are in debug mode by looking at a flag in the OTP || 0 if in debug mode

|-

|-

| 0x21 || 0x21 || int check_jtag() || Get the current status of the JTAG || 0 if JTAG is enabled or -4 if disabled

| 0x21 || 0x21 || int check_jtag() || Get the current status of the JTAG || 0 if JTAG is enabled or -4 if disabled